[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: modem config.............



On Mon, 1 Nov 1999, Matthew Collins wrote:

> >> s encapsulated in a black plastic sleeve
> > To people who build computers this means that you have a winmodem.
> Erm, no it doesn't. It does mean that the modem is correctly shielded
> and BABT approved (most likely) whilest the ones without the Black box
> tend to have not much electronics or shielding on them

Heh, I disagree with both of you ;) Winmodems *are* more likely to have a
black sleeve, because the frequencies on board are higher therefore
could do with the shielding. Being BABT approved doesn't mean it needs to
be shielded (the pc case can do that), the shielding is quite often there
not because of the RF output of the thing, but because of the high
voltages involved with the telephone system. That's why you have to
measure out the creep distance between your modem and your other cards
(has anyone here done this? No?).

> If it is in a ISA slot (like he said) then it won't be a WinModem, the
> ISA bus is not up to the job of being a WinModem, you need PCI for
> that.

What's this then? http://www.3com.co.uk/56k/wininchoose.html . I'm happy
to be proved wrong, but I didn't think there was any such bus restriction
on a winmodem?

> What it could be is a plug and play modem, in which case the IsaPnP
> utility will come in handy.

Isapnp is a good bet. If that doesn't find it, nothing will. Probably, a
good way to check if the modem is a winmodem or not is to send it a hayes
command? I.e., send it 'AT' and you should get the response 'OK'. I don't
know about this (someone will correct me, I'm sure), but I wouldn't think
a winmodem will respond to the hayes command set. If they *do*, I think
that's a rotten design decision ;))

Cheers,

Alex.

Start your own FREE mailing list at

© 2000 Microsoft Corporation. All Rights Reserved